FNProgramvare - View topic - Upgrade to Version 10

View unanswered posts | View active topics It is currently Sat May 25, 2013 8:41 pm

Due to enormous amounts of spam, the forum has been set to read-only mode.

Upgrade to Version 10

Page 1 of 1

[ 2 posts ]

Previous topic | Next topic

Upgrade to Version 10

Author

Message

glyjo

Joined: Wed Oct 26, 2011 9:09 am
Posts: 1

Upgrade to Version 10

I've just carried out the upgrade and converted all my databases. I expected the stamp view to show the new fields, Stamp Height, perforations etc, following the upgrade but this did'nt happen. Are there steps to go thru to convert from the old stamp view to the new. :roll:

Wed Oct 26, 2011 9:22 am

FredrikN

Site Admin

Joined: Fri Nov 22, 2002 3:52 pm
Posts: 13748

Re: Upgrade to Version 10


	glyjo wrote: I've just carried out the upgrade and converted all my databases. I expected the stamp view to show the new fields, Stamp Height, perforations etc, following the upgrade but this did'nt happen. Are there steps to go thru to convert from the old stamp view to the new.

To reset the form layout to the new layout in version 10, simply open the Stamp Edit window and choose Use Default Layout from the File menu. Select "Standard", then click OK.

_________________
Fredrik Nordbakke
www.fnprg.com

Wed Oct 26, 2011 11:05 am

Page 1 of 1

[ 2 posts ]

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to: