FNProgramvare - View topic - Stampcat V10 Perforations and Grouping Definitions

View unanswered posts | View active topics It is currently Thu May 23, 2013 6:49 pm

Due to enormous amounts of spam, the forum has been set to read-only mode.

Stampcat V10 Perforations and Grouping Definitions

Page 1 of 1

[ 2 posts ]

Previous topic | Next topic

Stampcat V10 Perforations and Grouping Definitions

Author

Message

richardj

Joined: Fri Jan 20, 2006 5:13 am
Posts: 4

Stampcat V10 Perforations and Grouping Definitions

Hi,
Just started to update the new Horiz/Vert Perforations field. It is auto-populating the Full Perforation field fine, however when I try to update my Grouping Definitions for perforations I cannot select "Full Perforations" only "Horiz" or/and "Vert". This results in the Grouping folders to only show either the Horiz or Vert sub-folder value.
Eg Vert: 13.25, Horiz:13 - will only show a sub-folder of 13.25 and not 13.25x13.

Hope that makes sense!

Cheers
Richard

Sat Oct 29, 2011 6:30 am

FredrikN

Site Admin

Joined: Fri Nov 22, 2002 3:52 pm
Posts: 13748

Re: Stampcat V10 Perforations and Grouping Definitions


	richardj wrote: Hi, Just started to update the new Horiz/Vert Perforations field. It is auto-populating the Full Perforation field fine, however when I try to update my Grouping Definitions for perforations I cannot select "Full Perforations" only "Horiz" or/and "Vert". This results in the Grouping folders to only show either the Horiz or Vert sub-folder value. Eg Vert: 13.25, Horiz:13 - will only show a sub-folder of 13.25 and not 13.25x13.

This is a known issue. Currently you cannot display the "Perforation Full" field in the grouping list.

_________________
Fredrik Nordbakke
www.fnprg.com

Mon Oct 31, 2011 12:37 pm

Page 1 of 1

[ 2 posts ]

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to: